Separate names with a comma.
Think my mack was delivered a little different from Holty's so far as wiring. Pump locations were the same (one just forward of the engine at the...
My apologies for having to do this from memory. Others feel free to chime in. There is no spacer between the rudder and the hull. See picture...
Welcome! Something to consider. You might update your signature to include location and specifics on your boat so when you have a future...
Will you access the boat from the stern or from the port or starboard side. Or will there be dock on the stern with a finger pier on one side?...
Great news, and a lot to be said for being stubborn!
Theoretically, once it is primed no; however, until the bowl is filled and gas is in the line from the filter to the pump, the pump will have to...
All I can say is that I love my 1990 Mack. Bought her new in early '91. You are going to love it!
Was looking at the Feb/March 2021 issue and on page 75 is an advertisement for BoatU.S. In the upper left quadrant is a picture of three tow...
Saw the statement, "Barnacles are readily removed by periodic brushing of the surfaces coated with Wearlon Super F-3M". What is "periodic"? and...
Location?
I'm drooling! Love the Pilot House models.
Edited my bookmark to get to Classic Shamrock (Jerry's) site as follows: https://forum.classicshamrock.net Suggest adding a new bookmark for the...
When you win, you lose.... I pulled for Buck's/Brady. Wife pulled for KC/Mahomes. I lost....
Thanks for the update. Truly understand "running behind".
Regarding the new website scheduled to launch yesterday, shamrockboats.com, this is what I observed at noon, Feb 2, 2021: Went to...
Ditto... Take lots of pictures, and back them up!
Want to go back to Redneck's point. If your gauges are indicating properly and oil pressure and temps are good, you can disconnect the wires from...
Two possible issues: Rough running cold, runs good warm, makes me think the choke is not set up correctly. Pump the gas once and the coke should...
If there is not a drain hose off the oil pan for sucking out the oil, would be surprised if this was the original engine. Look under the engine...
To expand on radioman's post, using the allen head cap screws, sometimes with a u-joint on the extension, enabled me to use a torque wrench.
