Separate names with a comma.
Replaced my blower about 3 seasons ago. Manufactured by Atwood.
Located in engine compartment aft.
Shamrock installs some quality water proof two...
Pump on my 1999 is located in transom.
Occasionally there is difficulty getting the pump to prime. I have considered moving it closer o the water...
Micron CSC is a high quality paint that I have always used with great results over twenty seasons.
Definitely locate the remaining impeller pieces.
I suspect its the "Hall Effect Sensor" located inside of the distributor cap.
If you need pictures of the Marelon ball valve installation I can accommodate you.
Failure? Just curious, my Teleflex unit has been flawless for over twenty years.
Advice: Only use Yanmar coolant or Dexcool mixed with distilled water.
Call Mack Boring.
FYI, mine drains properly, although slow.
Please take my recommendation from above and install some two ball valves in the transom discharge since...
I had a 182 mono color and really liked it with an external antenna.
Easy to operate, not supported any more. I would guess its worth fixing and...
Its a lousy design with the scuppers draining below the water line which limits the flow of water draining.
As a side topic, I suggest that you...
As a fellow New Englander good luck !
Eight degrees is too much backlash. I assume its hydraulic steering?
I don't think Shamrock is unique with regards to manufacturing issues, all boats have issues that are typically repaired if the vessel is new by...
Prior to placing the order for my boat in January of 1999 from Gifford Marine I looked at a number of used 246 opens and walk arounds whose swim...
The swim platform is only lagged not thru bolted to transom. Poor design and the reason I ordered my 246 open without the swim platform installed
Post some pictures, I would like to see the installation from the stern as well as inside the transom.
Look up Coosa board. Better product and alternative.