redneck
Last Activity:
Aug 24, 2019 at 8:46 PM
Joined:
Mar 2, 2009
Messages:
1,210
Likes Received:
31
Gender:
Male
Location:
Middletown DE
Occupation:
Cyclotron Engineer

Share This Page

redneck

Well-Known Member, Male, from Middletown DE

redneck was last seen:
Viewing latest content, Aug 24, 2019 at 8:46 PM
    1. huntinfish
      huntinfish
      Just pulled the boat this morning and downloaded the app iNstall on my phone and checked my deadrise by my in hull transducer. The app said I had a 14 deg. I dont have any mount blocks on my hull. So thank you for looking.
      1. redneck
        redneck
        There glassed into the hull right behind the front bulkhead in the engine compartment.
        Aug 17, 2019
    2. huntinfish
      huntinfish
      I wanted to get chirp in a transducer. So this is the reason I am going this way. Chirp up front and side scan aft.
    3. huntinfish
      huntinfish
      I was going with twin through hull transducers for side scan and down Image. So now I will go back to a flush mount through hull transducer and a skimmer on the transom that will give me sidescan and down image. Now I will have to pull the boat out of the water and get the deadrise for the chirp transducer. Ps do you know the deadrise on a 1999 246 cc walk around? Cant find this info on the internet!!
      1. redneck
        redneck
        I'm not sure what the deadrise is. I might have time this weekend to measure it since mine is a trailer queen. Don't hesitate to post up any questions it's a very friendly site and don't mind helping out at all.
        Aug 17, 2019
      2. redneck
        redneck
        The dead rise looks like 18 ish deg in that area in front of the engine where the put the mount blocks for the transducer's
        Aug 17, 2019
    4. huntinfish
      huntinfish
      Redneck just wondering if the transducer you mounted on the transom is a side scan? If so looking at your posted picture does the rudder block one side of side scan? I have a 1999 246 shamrock that is in the water as of today.
      1. redneck
        redneck
        It is my old Humminbird 998 Si that had both side and down imaging and i never saw any interference from the rudder. I don't see anything on my new Lawrance Ti9 either.
        Aug 15, 2019
    5. stubing
      stubing
      Redneck, sorry to bother you with last email. I realize you had a thorough explantion of how the chainlocker hole was finished off. That looks good to me.
      Thanks
  • Loading...
  • Loading...
  • About

    Gender:
    Male
    Location:
    Middletown DE
    Occupation:
    Cyclotron Engineer
    Boats,Guns,jetski's

    Signature

    Serenity
    07 246 WA
    5.7 EFI Crusader
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.